Moderator: CM Moderator


good place for plexi is http://www.glow-gallery.com...

Hi Shailesh,
No problem it's my job...
Well some of the parts where defective we found that the plastic part isn't
strong enough and that in some occasions with a little bit to much pressure
putt on it it breaks and starts leeking. This was enough to stop the
production for now I know that there are some shops still selling it but
these are the last ones available.
You could check these sites if you want to purchase them anyway;
http://www.sundialmicro.com/Cooler-Mast ... 34_488.htm
l
http://www.directron.com/rlsuccnu1.html
If you Google the item codes you will still find some stores which have
these parts on stock but better be sure if you buy one to check it very
carefully before unpacking it for cracks.
Best regards,
Robby Bottenberg
Coolermaster-Europe B.V.

Users browsing this forum: No registered users and 0 guests