00 InfiniTiS 00 - 2011 CM Case Mod Competition Entry

[d0g]

Proper fit for the unit and its harnesses

[d0g]

Custom made brackets made to hold wires behind the hard drive bay

[d0g]

and the back wall backets installed

[d0g]

Where the front was,is now the right side door

[d0g]

This door will hold a Cooler Master 200mm fan

[d0g]

Here is the heavily modified Mother board tray. The upper right hole will allow the 8pin power wire to pass though.
The back originaly housed one 80mm exhaust fan. After cutting this area, it is just big enough to stack two 80mm fans now.
The large hole in the middle was cut to gain access to the back of the mother board to ease mounting of the processor.
The round holes were cut for ventilation and center the rear 200mm fan. The angles will be mounted on the back and will channel wire around the
fan. I also made an extension that will be attached to the right front. This extension will allow the main power harness, sata,
power switch, and video card cables to pass though for an ultra clean look. My goal is to hide as many wires as possible.

[d0g]

The tray facing front with the extention mounted on the right (more holes were drilled for the vc and switch)

[d0g]

The back of the tray with angle mounted acting as conduits for harnesses

[d0g]

The military grade mb. (no aluminum caps) look closely, not one.
I had two caps burst on me over the years. All boards should be made this way.

[d0g]

The mb with the tray assembly

[d0g]

Mother board mounted with I5. Here you can see the 8pin power cable, the first of many carbon fiber sleeved cables.

[d0g]

Custom cut cpu and gpu temperature guages mount assembly

[d0g]

Installed temp guages (the cpu will light blue, gpu green)

[d0g]

Custom cut backet for rear fans exhaust assembly

[d0g]

Rear 80mm fans installed